Gjallarhorn
Probationary Member
- 10
- 1
- Jun 7, 2017
-
Houston,
Texas
Hello,
So I finished putting my engine back together in my 96 2G and when I went to start the car it idles well but dies after a couple of seconds. It does not turn off immediately, it starts to bog down and shuts off.
I'm trying to upload a video of the issue, but I am having trouble doing so. Will add to post once I figure out how to do it.
I have verified the following:
- TPS at .63v
- no fuel leaks, AFPR set to 43.5 psi
- fresh 93 gas
- Omni4bar enabled under MDP on ECMLink
- Plugs and spark plugs are new (NGK BRP6s gapped to 0.032, NGK wires)
Mods:
- speed density (IAT sensor/ omni4 bar)
- Fuel labs AFPR
- Walbro 255
- big 16g (wastegate pressure)
- FIC 650cc injectors
- Front mount intercooler
- AEM wideband (wired to rear o2 sensor)
So I finished putting my engine back together in my 96 2G and when I went to start the car it idles well but dies after a couple of seconds. It does not turn off immediately, it starts to bog down and shuts off.
I'm trying to upload a video of the issue, but I am having trouble doing so. Will add to post once I figure out how to do it.
I have verified the following:
- TPS at .63v
- no fuel leaks, AFPR set to 43.5 psi
- fresh 93 gas
- Omni4bar enabled under MDP on ECMLink
- Plugs and spark plugs are new (NGK BRP6s gapped to 0.032, NGK wires)
Mods:
- speed density (IAT sensor/ omni4 bar)
- Fuel labs AFPR
- Walbro 255
- big 16g (wastegate pressure)
- FIC 650cc injectors
- Front mount intercooler
- AEM wideband (wired to rear o2 sensor)