This week I had a goal of starting the car and getting the wheels on. Last time I mentioned I only had about 4 thread engagement on my front wheels. As a result, I ordered lengthened ARP wheel studs and new lug nuts. I ordered a couple pair of...
Considering you have a 2gb Eclipse, the 7" ETS core might not fill the entire opening, , I think the opening is taller than that.I personally run the Treadstone TR1045 but they also have the TR1035 which would be more fitting to your needs...
Almost forgot!
Before sending to the tuner, I got the dash in and hood situated - new aerocatch latches and a custom made hood vent.
Car was cleaned after this image, admittedly.
Will have to get a completed interior pic once the car gets back.
Solid body, two small rust spots in the rear wheel well, in front of each tire, where the bottom molding connects, not visible from the exterior. Kentucky, about 90 minutes from the Virginia border.
Not much of an update. Worked on getting the fender and plastics all setup perfectly. With 32 yr old plastic that has been warped over time, it wasn't fun. Having new clips in all the proper places made it difficult to line everything up the...
Big update, the entire drivetrain is finished besides the axles. Still waiting on dss for those. But happy with how everything turned out and honestly was not too bad to install. The JXB carrier bearing housing was pretty straight forward and...
Got to level and square this all up so I can attach the tube to the new mounts. Don't mind the rad inlet and outlet ports. The rad is flipped temporarily so the nubs will hold the front up.