HelloWas hoping to revive the battery relocation thread but maybe this is easier. A lot of the pictures and links are dead which shows how it was done. There seems to be a lot of different methods but does anyone have a diagram showing the...
Reviving this thread from the dead. Does anyone have a diagram for the 2g relocation and no kill switch, there's alot of dead links for diagrams and so many different versions over the years. Was hoping to relocate my battery this weekend to the...
Used JMF Intake Manifold, has been tapped for an extra vacuum port on the back. Has some left over silicone on the backside around the ports. Was there to ensure there was no leaks on the previous installed barbs. Could use a good polish but no...
Wondering if I should also relocate my catch can, not sure if that will make a difference. Currently relocating the battery to the trunk so I will have that location open. Currently it sits down by the rad behind the passenger headlight
Have a recently rebuilt S90 throttle body. Rebuild was done by Nick R.Comes with block off plate and new gasket. Has a small dent in outlet lip (can be seen in photos) but no issues with it. Small amount of gasket maker on it but can be cleaned...
All pipes and couplers are dry. Was just in the manifold and coming off the head at the runners.I have the catch can down by the overflow tank. Currently route like so.FP intake, drilled into the side of it and that feeds the side of the...
This afternoon I removed my JMF smim and notice some oil sitting in the runners. Motor is still in break in after being built by MAPerformancd, have about 60km on it since then. I’m running a catch can off the valve cover with a check valve. I...
Hello,Was looking for some insight, I've been building the car over the past year and essentially ran out of time before the snow came to get all of the gremlins out of it. Originally we tried to tune it after the enging was built by MAP but...
HelloJust installed the 02 housing from stm and I currently have an alternator and AC installed but the wastegate is pretty much on top of the alternator. If I loosen the alternator anymore the belt will be too loose. Just worried about it...
Hello,I just purchased a 38mm wastegate (Tial MV-S) and am trying to figure out how to install it. It will be paired with an STM 02 Recirculated housing , i have seen so many different methods of using the top port opposed to just the side...