Hello all here is my story. I have a 99 Eclipse GST.The problem I am having is I had a cloud of white smoke all the time when I drove my car and thought it was the turbo. I took it apart and could not find anything wrong with it. This past weekend I did a compression test because the idle...

i have 98 gsx and i broke my tranny again, will a 1st gen awd bolt right on?

Can I run more boost with arp head studs?

I have a 99 GST and ran a oil line thru the rubber cover on the steering column and now when i boost above 10psi i can hear and smell the boost coming from that spot, does vacuum go thru that? or am i missing something

thanks for all the info

No, head rebuild and decided to do the short block too.

thanks but this is the 7 bolt the had the old style bearings, mine is the one that uses the 3 piece unit

I have a 99 gst 7 bolt, had the engine rebuilt only have 127 miles and have crankwalk, my question is why cant i put a 1st gen bearing in the top middle with the lips on it (it does fit) beacause it makes a perfect fit so and endplay is with in specs. everyone has told me that you cant do this...

Thanks for all your help, I did check the end play and its within specs. and again the engine now only has 120 miles from rebuild, this was a full long block rebuild

this was already done.

I have a 99 GST, was just rebuilt and only has 57 miles on it. ever since I installed the act 2600 clutch first off I had to put washer behind that ball on the tranny because the car would not go into any gear, so with that I also replace the master and slave cylinder, but every time i depress...

I just bought a 7 bolt jasper engine and it does not come with the balancer shafts, why? wont the car shake more? Thx.

I have a 98 GSX and the problem is when i turn the wheels either way, all the way, the rear tires seem to drag, is this normal?

My problem is when my car reaches boost of 15 - 17 psi the fuel cut comes on. I dont have the boost solenoid hooked up. Im currently running the following,94 Octane Air Intake 3" down pipe 3" exhaust Walbro 255 lph/HP fuel pump FMIC Big 16G Ported O2 housing Manual Boost Controller...

99 GST I had the dealer install a act 2600 after my tranny got fixed. I was told i needed a new clutch master & slave cylinder because they where leaking, so I replaced them, but it is almost impossible to put it in gear since the clutch was installed.

here is a diagram of the power window. Try the relay put one of the other relays there.

hey guys i want to upgrade my stock t25 to a 1g 14b turbo, how much is the kit to install it?I also need to get a rebuild kit for it. there is a little damage to the blades and little shaft play. I appreciate any help.Thanks.

is it possible to upgrade a t25 to t28, if so where can i buy a upgrade kit. also where can i find a rebuid kit for the 14b also want the blades. thanks