I've noticed a slight tick or rattle when I'm at a dead stop and give it a soft rev. The sound appears when the rpm's are almost back at idle. I've done ove 5000$ of major maintenance like timing kit/ water pump, clutch, flexplate, all engine and trans mounts, drive belt, thermostat, valve cover...

Bought this car with bent valves. Replaced valves and got it in time. It runs pretty well now, I just get this noise when above idle. The tachometer doesn't work, but turning the steering wheel and causing the power steering to kick in is enough to slightly get the noise. The noise does not...

Hi all, hoping someone may have come across this issue and have some advice for me. Just fitted this wrecker sourced 4g64 engine with 161k to my WA Exporess van. When first run engine sounded noisy as with lots of lifter noise, but then settled down after a few minutes. Took it for a couple of...

So i bought a manual 91 eclipse that was missing radiator, intercooler piping, battery, rotors/pads, exhuast manifold and had a huge crack on the turbo. After a couple of days of swapping parts from my 92 talon tsi (snapped a band in the tranny and is now parts car) and finally figuring out why...

After doing some searching on here I'm thinking it might be a balance shaft, bearing, or tensioner going bad. The noise can be described as either light grinding or a rapid rattle. It's definitely localized near the timing belt area, at first I thought it was coming from under the valve cover...

Hello everyone, I'm new to this site and could use some help. Last year just before Christmas I bought a 99 eclipse Spyder GS. t's 4G64 engine 2.4L automatic. The car wouldn't start so the owner let it go for a low price. AAA towed it home for free and I began to look it over, long story short...

I recently fixed the notorious window rattle problem on my 2G for the drivers side and wanted to do a thorough writeup because it seemed all the previous tutorials had missing pictures and steps. My drivers side rattled a tiny bit and I wanted it gone, so here is the fix.Tools you will need...