I’m currently looking at some 1998 mustang gt injectors that are rated at 24lbs an hour as an upgrade to my 19lb stockies does anyone have any experience with them, I’ve heard they’ll fit but I’m not 100%
So first time DSM owner here, I have a 97 Spyder GST.When I got the car it had 650 cc injectors with a SAFC2 air flow module installed. I got the car running and was running super rich, so I wanted to switch back to stock injectors so I didn't have to use the module.Now that the 450cc...
Selling a set of 4 working 950cc injectors & an aem 340lph pump. Injectors were pulled in working order (could use some new seals). Pulled to upgrade to 2200cc. Pump was in car since November of 2021, working as it should. Included will be the set of 4 injectors, the pump, & pump install parts...
550cc injectors. Great upgrade for a mild DSM build (up to +100HP over stock). Would pair well with a 1g with a 2g MAF or with using a Super AFC.
$55obo
Paypal preferred
Used set of Precision fuel injectors, 950cc low impedance injectors. Ran great on ECMlink when removed. Upgraded to FIC 1650cc's when I went flex fuel. Price is shipped via PayPal.
Hey guys,
So I recently got a 1995 eclipse gst with a 6 bolt thats fully built. Over $15k of upgrades in the car and I paid $2900 for it.It didn't have a timing belt on it when I bought but after being timed I got super lucky cuz it didn't have any valve damage.Shes running now but I'm...
FIC 850cc injectors. Comes with o-rings, rail gaskets and manifold gaskets. Never installed them and purchased other ones. Price is negotiable. Buyer pays shipping.
So I'm in the process of pulling the motor/trans in my 2g awd. While removing the electrical clips I pulled the injectors. I had just cleaned the whole engine bay in the beginning of summer. Though, when I pulled the fuel rail I noticed it was dirty around the injectors. Sand could have fell in...
Going to be swapping from my 450cc to 680cc injectors today and I am curious on the latency values. Do I just add to my current values the recommended amount for the 680cc?
So I have the opportunity to get some 560cc evo8 injectors local for $100 maybe less depending on some feedback from you guys. I've been looking around for some 650-850cc injectors and just can't find any for a fair price. I'm almost at the point of just buying brand new.I noticed one of the...
Not sure which wire goes to what. The 2 on the car are different colors from the 2 on the clip/injector.The car currently doesn’t run/ doesn’t have a battery so I don’t have a way to check voltage.I’m sorry I’m advance if I posted on here wrong, I’m new, and suck with technology!
1000cc PTE injectors - SOLD
Stock 2g Exhaust manifold - $30 + Shipping - SOLD
[1G] MAFT v2.02 - $130 Shipped - SOLD
Large FMIC 3" inlet/outlet - SOLD
White high rise eclipse spoiler - $100 Local pickup only.
Good condition tan rear seats - $100 Local pickup only.I think that's everything...
Selling some extra parts that I got with my car, no issues with any of them. I already have a smaller front mount installed and only have the stock turbo so no need for a large intercooler or 1000cc injectors.I also have a ton of interior pieces that are in good condition. They are mostly Tan...
For sale is a used but good condition set of PTE 680cc injectors. 120 shipped or best offer.Will need new seals. Here is a link from STM:
https://stmtuned.com/products/pte-fuel-injector-seal-kit-for-4-injectors-mitsubishi-580cc-1200cc-injectors
16g eBay turbo 1000 miles with headers and dump pipe.-$200
Stock fuel rail with 560cc injectors-100
T3 eBay manifold-100
7Bolt Bare block (80k)-150
Stock cams-75
7bolt flywheel(needs resurface)-50
I recently bought 450CC injectors for my automatic 1G, and I'm wondering if it would be wise/nessecary to also install the fuel pressure regulator off a manual turbo 1G. I believe the PSI on the auto is about 43 while the manual's is about 39.And before it's pointed out, the previous owner...
1). No boost, vac, or exhaust leaks. No noticeable leaks
2). Verify mechanical timing. Fresh timing belt, properly setup
3). Verify base timing. 5°
4). Ignition system. 028, NGk br7es
5). Motor health. Fresh Build, about 1k kms on it
6). Basic throttle body adjustments. Adjusted and tight, TPS...
I'm uninformed about fueling, bear with me.When buying injectors, what stops someone from going straight to something like 1200cc? I've seen a lot of people buying something like 900cc injectors, maxing them out, then having to buy bigger ones anyways. Is it bad to run large injectors at a low...
Turbo.
Pte 6165 DBB rebuilt as gt35r/gt37r hybrid with brand new billet gt35r 11 blade, brand new large frame BB cage, brand new gt37r turbine wheel. .63ar t3 turbine cover, .70 anti surge compressor cover. All genuine garrett parts. 0 miles never used. Good for quick spooling 600hp...
ive looked all over and can’t find a post that explains how to do thisI have Bosch 650cc injectors that I haven’t put in my car yet and I’m trying to figure how to tune for them with dsmlink v3 after I have them inCan someone explain how to do it?
2G Front Fenders (pair) asking $150 a fender (minor scratches, no dents or rust.)2Ga TSI Rear Hatch w/h spoiler, harness, and window wiper assembly $200You cover shipping. All prices are obo, please no low ballers. Thank you.
Hey guys, I recently upgraded my fuel system to accommodate more power. I have installed a DW 255 fuel pump(rewired), fic rail and 750cc injectors, and Aeromotive fpr. I have set the fuel pressure to 42.6 or as close as I can get to it. I have tried setting the global fuel to -39.8% and global...
EVO 8 injectors. Seals are ok but should be replaced ideally. $80, shipping and PayPal fees included. I will only ship to the address listed on PayPal. My PayPal is [email protected] First come first served. Use same email above with questions / need more pics.
Posting an updated ad and removing previously sold itemsSilicone Radiator Hose for '95-'99 Eclipse - Bought from import evolution in 2010 - $45 shippedDenso 1020 fuel pump, never used, $90 shippedMAP DSM-RDB-2G Clearance AP Spec Rear Differential Bushings for 2G DSM - $80 shipped1200cc -...
Hi!
I have a EU spec 2G with N/A 4g63 wich is mostly stock apart from the exhaust system. I'm planning on a fuel system upgrade with a walbro 255 pump, and 1000ccm injectors, wideband and fuel pressure regulator. I have some kinda rookie questions about this setup... Do I need dsmlink or...
Hey guys,
I'm performing a small garage clean out. The following parts are just what I have put into a list at this time.
If there are other items you need feel free to ask if I have it, though most of what I have are used OEM parts. Prices don't include shipping, however prices can be flexible...