I have a 1997 Mitsubishi Eclipse gsx. The car drove just fine before for a while. The main problem I had was my speedometer didn’t work. I drove for a while without getting that fixed.Sometimes it hesitates getting it to start up. When I accelerate it won’t catch up to speed. It dies when...

Admittedly I inherited this problem with the slim fans (set up to be pushers mounted to the front of the radiator) on my car as they were installed before I bought it. Problem is I don’t think they ever worked and I hadn’t driven the car in stop and go traffic before so I hadn’t noticed any...

Glad to find such a knowledgable community to support my new found DSM afliction. Here's a few pics of my 99GSX I picked up 1st of July. Exhaust was garbage eBay and it had several small issues I have worked through. ItsI running ok now, but I will be seeking some Yoda like insite on getting...

Hey guys I was looking for some help on my 2gb dsm. I recently just installed new 9006 bulbs for my low beam headlamps and they only work when i have my highbeams on as well as when i flash the headlights. All my fuses are good and the headlamp bulb wiring seems fine, however i do have two wires...

I have a 98 gsx, 6 bolt and 98 black box ecu. i have a fresh adapter harness for the CAS and i am unsure where to connect the 4th white wire on it

Can anybody tell me how im supposed to wire my spark plug wires i have a 98 GSX with the 6 bolt swap and a black box stock 98 ECU I currently have them wired from coil 4,1,2,3 and the car wont stay on for more than like 5 seconds , i figured it was my CAS harness which i ordered another one but...

Hey guys,I was going to start building a new long block but decided to restore my original one instead.Up for grabs is a freshly machined 7bolt from a 2G Talon 121k miles. Craddle and ARP main studs also included. Bored .20 over. Asking $450.00 Cell is 203-675-7695 - BobPhotos for...

I just put my '99 GSX back together after replacing the clutch. I put my old battery back in (which worked fine before but has been sitting for months) and attached a jump starter to the contacts. I also made sure it was grounded from the negative contact, the same way as it was before. First...

I have a problem with my 98 GSX. I’ve heard a grinding noise from my front passenger wheel. I tried wiggling everything but it’s all tight and good. The grinding would go away after about 20 mph. Now it doesn’t go away and I slow down a lot faster. I’m thinking my brakes on that wheel are...

Looking to get back into this platform, vehicle must have a clean body and have some stock parts available but not installed. Looking to spend up to $ 5000 but can go up depending on conditions.