I found a source for OEM style male and female pins for the interior connectors. With pretty much all the old suppliers for pins gone, it was very difficult to track this style down. The only readily available Canadian source was Mouser, but searching the part number may yield other sellers as...
Hello all! I'm in the market for a 5 speed AWD transmission, capable of holding down ~350-450HP should I do a little more upgrading in the future. Looking at shops like TRE, TMZ, Jacks, etc. staged rebuilds are a thing of the past and most rebuild options look like they're targeting near stock...
I was looking at getting a key fob for my talon, so I tore into the guts of my backseat to see if I had a keyless entry receiver. Good news is I do, bad news is there is seemingly no information available for my unit (FCC ID: GQ43VT8R), only a single comment on the entire site (besides this...
This is a last summer problem, but I'm just getting around to it now while the car is sitting in storage. My engine bay smells like coolant. Hot coolant. No sweet or fishy smells, just smells like if you took a jug of antifreeze and got it nice and hot.I don't see any leaks, nothing pooling...
Hello DSMers!I've recently been pondering the idea of having a dedicated single key switched race mode for my talon. I know to some extent that this could be accomplished by using ecmlink's secondary maps setting via the idle switch or custom FPS/EGR settings. Part of any good race mode would...
Hey there DSMers, I've run into an intermittent no start condition which I believe I have pin-pointed down to the MAP sensor. It's a mitsu style Omni 4 bar, about 3-4 years old by now. I have checked timing, spark, and fuel. Didn't get the chance to check compression before I killed the battery...
BOTH ITEMS LOCATED IN CANADA!Koni Yellows:
Bought these used, unknown mileage, decided to go a different route with my ride, bought coilovers instead. One strut looks like its leaking a little out the adjuster knob. The other three look okay, but I would advise getting a rebuild for...
LOCATED IN CANADA!Bought these used, unknown mileage, decided to go a different route with my ride, bought coilovers instead. One strut looks like its leaking a little out the adjuster knob. The other three look okay, but I would advise getting a rebuild for longevities sake.The following...
I’ve got my motor apart, the crank is currently at a machine shop getting spec’d and polished. I figured there’s no point in buying or boring anything until I know the crank is good.In the mean time, a little bit about the motor.7-bolt with 200k km (~124k miles), no fuel upgrades (yet)...