I can probably find one non turbo for around 200 here. I'd probably swap the engine and sell if its another 2.0 non turbo so asking if there are easy swaps for better engines as then I'd probably keep the car.
So I spun a rod bearing and my local mechanic told replacing it would cost 500 and up. I can't replace it myself as I don't have garage so he said it would be cheaper to just swap the whole engine. So my question is what engines are easy swaps or should I look for only 2.0 4g63 again? And from...
Thank you for your replies. The issue was i i atached b terminal in wrong place. Thats what happens when you take out your alternator and put it in month later. Everythings fixed thanks
Today i replaced my alt with new one and 80 amp alt fuse just blown. Put in new one blew again. Did i connect everything right? And alt is 90 amp shouldnt fuse be 90amp too? The last alternator was 90amp too but it didnt blew. Any ideas?Also all my accessories like radio windows heater and...
So today i removed my side skirts and found a lot of rust. The car has no rust pretty much anywhere else. How much of a problem is rust there and is it pretty common in dsms? Cutting it out and welding new metal plate will be too expensive for me i imagine so what are my options?
Finally got that little metal connector for the wire. Im pretty sure but just gonna ask because - wasnt conected anywhere - can you ground the starter to the same 1 of 2 bolts that holds the starter?
Thanks for fast responses guys will check wiring tomorrow. Also I wanted to ask if what I did could have anything with this issue. On the firewall just behind the battery there is a hole for all the wiring to go. When I installed sub I put pretty beefy wire and I ran it together through that...
Couple months ago my starter died. It made no noise at all. I pulled it out and one wire to carbon brush was broken so I replaced it. After a month the same issue appeared. I drove to a shop (it started perfectly on my way to shop) and when i wanted to go back it again made no noise at all. I...