Garrett 100% unless you want to go cheaper and laggier go with something cheaper. My gtx4088r made just over 500whp at 16psi on pump....that was on a 2jzgte though. It created full boost right at 4K though spools insane fast. I’d suggest a gt35 series for the 4g63. The gt40 is a 1k hp capable...

Perfect

Like title says, and I’m new so hope this is in correct area. I don’t want to put anymore money into this car as I’m trying to get it back together and sell. I have a 96 tsi awd (Gsx) with a built 99 motor I pulled from a GST. I didn’t realize at time or I would have just pulled the ecu from the...

Ok I’m very confused and I’m sorry but want this swap to go smooth. Engine still out but want to install. I got to location where the CAS should be for a 96 motor on the 99 head. I see screw holes and were I believe it goes but there is no hole into head just aluminum about 1/2” in. Is this...

Problem is no engine in car. Therefore if I turn key on fuel goes all over etc. plus no transmission in car too

Ok so I have a 96 talon and have taillights from 99 eclipse I’ve done full conversion but can’t remember what wire from talon is for the reverse lights. Any help. I have wires fed from eclipse back up into rear but need a reverse power source. Any help thank you. I don’t have anything Talon...

Ok if I do that is there any issue just leaving the 99 sensor in to fill the hole? .

Dang sounds like a lot of work. Would it be easier to just use the 99 sensor? But if I did that I would need a 97-99 ecu?

Shoot ok looks like I’ll havwshoot ok looks like I’ll have to source a 95/96 cam sensor. Sorry again but mentions in different locations? Does that mean I have to tap in different location for cam sensor or just change sensor itself out?

Well shoot that ecu is gone. It also was for a GST not a Gsx does that matter?So if I use an older ecu what do I need to rewire? Or rearrange and why? Sorry new to dsm but not new to modifyingAlso have Apexi tuning devices I was going to use for fuel and boost so which ecu is easiest to...

I Thought you where giving me advice putting it back together but I already have coolant feed going to turbo haha

Honesty just putting car back together so I can sell it. Buyer I had backed out last minute so I said screw it I’ll build car and then sell. Motor is 99 with 20g turbo, tial wastewater and dsm lightweight pullies. Ran well when pulled from 99gst. Now putting in my 96 awd

Would it be worth sources components off an early engine or just do some rewriting?Ok so does starter relay need to be reworked to use 99 motor? What is FP check connector? What ecu should I run? Is the Fuel tank diff sensor needed for 99 motor to run correctly?

Thank you guys for all the info. Reading through what’s different does it all need to be changed or is that just reference to what’s different? Like the abs stuff etc.

Talon tsi awd and eclipse Gsx exact same car besides some body trim and badges