I've had mine for 18 years jdxcn 😜T25, Honestly the spool on that thing was LOUD and would bring a huge grin ton my face on WOT and I loved it. then I switched to a Chinese Evo 3 16g I purchased from god speed project and it got a lot quieter 😢..... All of this was done back in 2006. That...

What ^ said =D

You are right, Running AC here.

I normally run the traditional Prestone 50/50 mix and had never had any issues. My cooling system is pretty much stock aside from just a higher pressure radiator cap (1.3 bar if I remember correctly) and some redline water wetter which I decided to add just because.As for the VRSF FMIC...

🤣 Holly thread revival huh lol.

With you on this one as well. When it gets to 90+ down here not once did I have an overheating issue, that is with a VRSF FMIC, mind you I cut out the black upper portion of my front bumper as well as trimming the same amount off the crash support bar. All of my cooling system is also stock...

hmmmm odd.... either way in my case the hub that is not tapered down did not work but the one that is does 🤷‍♂️

Hmmmm I don't think a powder coat would make such a huge difference but it is something to look at.... The wheels I got do look like they have a factory coating.

Idk about that... DSM center bore is advertised as 69.... Even the Evo X is.... but the Evo X wheels center bore is 67mm so something is off. From what I've learned is that a Dsm and Evo VII-VIII have the same measurements all around; Evo X still has a cloud around it. Can someone else...

Do you have a picture of your OEM hub that is currently attached to the car/Evo X wheel? the only other thing I could think is different is that the early 2g Dsm had somewhat of a different bore than that of the later ones. if you can please provide a picture of your hub attached to the Evo X...

How sure were you that your hub was OEM? Did it look more like my first picture or the 2nd one? I had about a 5MM gap with the hub I'm assuming is OEM vs the one that is reduced. Pictures of OEM hubs look more like my 2nd picture...

18 Years here with my 2g 😁

Attempted to test fit some Evo X Enkei Wheels on my 2g..... contrary to what some people have said about being a direct fit, they are not..... BUT.......... I found a solution; If you have what I think are the factory Hub assemblies the wheels will not fit. Most, if not all aftermarket hubs...

Here is a good one:Got the auto trans rebuilt on my DSM, after a couple of days the car lost power, every time I would step on it, it would just take a nose dive and not go.... If I would drive like a grandma everything was fine but the moment I tried to punch it it would fall on its face, my...