Ok so I replaced the battery for car cause it wasnt holding a charge I now have a good ground with key on but I still dont have spark or fuel injectors arnt firing with the diode light in the harness would think i need to replace crank sensor
I know when I took the old can sensor of it was melted but dont know if that could cause something to short out, when I bought the car the guy said he had it running and it just quit found out it had bad compression, so I have never had the car running but I do know that the ECM isn't showing...
Well I bought the car with a blown motor so took it out and rebuilt motor and head all new timing parts new cam sensor crank sensor all grounds that I know of have been cleaned and re installed my head and block our grounded I have checked all fuses and they are good motor will turn over but I...
Ok then what would cause me to lose my ground when switch is turned on cause I'm losing it at the cam crank sensor and coils and tps that's all I checked I can go further but they all run in same harness
95 eclipse 4g63 I couldn't get car to start no fuel or spark so checked my cam and crank sensors I have 12v on Red wire 5v on blue and continuity to ground on both connectors when switch is off, but when i turn ignition on I lose ground I also lose ground on tps and ignition coils plug which are...
I'm having issues with my 95 eclipse 4g63 I rebuilt the motor cause it was bad when I got my car and put it back in but now I cant seem to get the car to start I have changed cas, crank sensor, coils, power transistor(icm), it will roll over not sure if it's the ecm or not the injectors where...