Alright Fellas, we waited a little longer for a small lift to come in. Got it built during the week and put it to work this weekend. Today we removed the old and busted radiator and installed the new Mishimoto system. Went in smooth, we replaced the thermostat while we were in there. Pulled the...
Wow. Has it been 8 months...good thing I have another 4 years before she can drive. So pretty quickly after this work we did in Jan, I took her for a spin, and during that drive it began to get difficult to get it into 1st. I was thinking I needed to take it to the trans shop, was thinking big...
Hey Team,So we are moving along with the build steadily. Since the last update we replaced the following:1. Master Cylinder: After replacement I still have a difficult time getting the trans into 1st. I discovered that if I place it into any other gear first and leave the clutch in I can...
There is a large port on the front side with a plug yes. I have a second oil filter housing that had two of the 1/8 BSPT ports. One in the front and one in the rear. However the installed had only the 1/8 in the rear and where the other should have been is a stamp. I understand what you are...
Yes I saw that there should be a spot for it, however on my housing there is not port, there is a stamp in that spot which I thought was weird. The only port that is that size is where I added the T. Previously the dummy light was there and there was no gauge at all. Thanks for the info.
Figured I just reuse this old post to ask a related question to my original. I ended up installing a T fitting in order to get both units installed onto the oil pump. I have more details about the installation in my build thread. However to make it brief since the change my oil pressure light...
Just thought Id take a minute to update the build and ask a couple questions on the forum in regards to the changes.Two weekends ago we replaced the turbo exhaust seals and replaced the vacuum line. I replaced all but one of the turbo exhaust bolts, I was unable to replace the one which had...
Thanks so much Dusty! I actually do have that port it looks like. Some one rammed a screw into it. I was not sure that was what that was for as it does not appear to have a nipple like the other ports for a hose to clamp on. Thanks a lot for the pictures also. I see on your oil unit that you...
Hey Team,So awhile back I posted the pictures of the engine bay and a couple of the guys saw that I had a T in my BOV vacuum line, and said that I should remove it. So I ordered up a bunch of new line and started to work on that on Friday. Following the diagram, I noticed that the aftermarket...
Hey guys! A couple weekends ago we swapped out the stock brakes for the PowerStop brakes. I did the drivers side and explained the process and the components along with their functions. Then Akayla did everything on the passenger side except breaking the bolts loose :). Here are some of the pics.
Okay did a little investigating on that T in the BOV tubing. It seems to go down to the waste gate actuator, not sure why that was done, there doesn't seem to be another line ethier, which is suppose to go to a waste gate solenoid. Here is the diagram I was referencing: