Have a strange situation with this seal leaking and looking to see if anyone had the same issue once upon a time and what fixed it?Just had the T Case rebuilt so all parts/seals are brand new, there is no movement in any of the parts etc. Notable mention about this issue is that I didn't have...

For those that have the Evo 9 rims what tire setup did you like the most or least the best on a 1g? Looking for tires that have good grip but not wear out too fast. What size did you find fit the best?

Time for everyone's opinions suggestions and inputs on this one. Working on a little flywheel project that may benefit us all, Well AWD 6 bolt guys for now anyway 😁1. What would be the preferred material that should be used for a flywheel? Example: Aftermarket companies use 4140 Alloy stamped...

Sure would be, as I have read all the posts on the Saturn alternator mod and wiring and there is many conflicting posts on what is the proper way to wire it in the car. Most common issue seems to be where is the proper location for the S-Wire as this is the most important to have right, If...

Looking for some ideas or suggestions on what type of fusebox you used or would buy to move some fuses/battery around etc. Feel free to put your pics of your setup. It helps with ideas.Looking for an all in one as small as I can get but sometimes that's not possible fusebox to power the...

Is this the mount your missing a bolt from? If missing 1 bolt from this bracket isnt as bad as the mount below as you have 2 bolts but i would still put a bolt in there.or is it this one, specifically the 2 holes in the middle. If missing 1 bolt from either of these holes I would not...

Sounds like the Timing cover is rubbing the belt or oil pump gear slightly. Looks like you have more than a few bolts missing. Try removing cover and see if you still have the noise. Maybe the Timing belt belt is too tight?

Working on getting the electrical up to date and made the cutest little thing. Lol Well they say keep your grounds as short as possible, I think I'm good :D:D. By the way that is a 1AWG cable.

Check for leaks behind the slave cylinder and master cylinder boots. may need to bleed system again.

Look until your eyes get tired. :DEclipse Overload

If your out of time and need to move it fast, best option is call a towing company to move it for you. I cant count how many techs I have see do it this way.

This maybe the 3 hard to tell what that the red car is after the white one in the middle, too bad the other white car wasn't next to the white what looks like an eclipse?? then this would have been the closest to the challenge.Keep searching guys..

Wow. Closest one yet but not quite there. Whole lotta talons in there.

Could be a multiple of options to check for you to solve the issue, have you checked your Master/Slave cylinder for leakage, Might need to adjust master, Shifter bushings worn out ,low fluid level, air in the system those are the simple easy checks. Worst case is transmission needs to be rebuilt.