Let's see if I can get some pictures going in here! I've had the headlight covers off of the car for probably close to 7 years now. I decided to make a change! I made some quick tabs out of aluminium riveted them to the hood and then attached them to the covers. Then covered the seam with...

Alright let me bring this thing up to speed.I switched this thing over to an auto a couple years back. I didn't get much time to work things out before receiving orders for recruiting duty. While I was out on recruiting duty I hit the track one time in 3 years.Recently I pulled it out of...

Partout- /end

This thread saved me hours of wire chasing! Never knew that noise capacitor would ground out! Had the same issues as the OP. #MakeFourmsGreatAgain.

Sucks that your first car had to have air bags... BUT!You can sell it now and move onto your 2nd car and buy a 1g :)

I ran across this while building my transmission. I found that either my rear or front clutch discs were not fully seated.You need to assemble the kickdown drum, front clutch, rear clutch at the same time then slide it into the trans. This ensures that both sets of clutch discs are on...

Well it broke 1st gear at the shootout. Got it fixed made one more pass and it shot a brush out of the Weldon fuel pump.I bought an auto setup the day it broke..HahaAfter the last pass I went down to kigglys tent and bam! I'm officially sponsored by kiggly racing!!I think that...

Cutting it close! But it's the shootout you have to build your car the night before, its a requirement! :thumb:

I'm AWD and I can't get on the dyno!

I'll be up there thursday night. Friday making some test hits to get my balls back.

Yes I filled the block but set it up so I can still use the OEM pump :)Ok quick update. I've posted most of this on facebook and talk.10 lbs per side:I know she's not the prettiest. She may not be built like everyone else builds their cars and does their tubes. The...

Looks really good!For mock up of some parts / wiring I just tossed in an empty block, head, empty trans case and tcase. Made it easy and it wasn't a pain to put it all in there just for a mock up.

No spray. Happend mid gear. This was on street tires. Boost was around 20psi.

Welded center, open front, lsd rear.I figured I planned on tubing the front and my car figured well #### it he needs motivation to do it!

Right rear kicked out tagged the wall and sent me sliding passanger door first down the track. At about 110mph..I was in the right lane and hit the wall on the left side. Not exactly sure what happened.