i recently installed the BM LSD tranny insert and a act 2100 today. the car doesnt go in gear after we started the car. while the car was off it went into gear. we put the car in gear while the car was off and than tried to start the car while in gear the car would jerk forward(of course we had the clutch pedal down). the jerk is like...when u start the car in gear and let go of the clutch it jerks forward. wut did we do wrong?

Who installed the clutch and did you guys use a clutch alignment tool?

more specifically, did you bleed the system after the install???

sounds like air in the system

Check out my post, I had the same problem.

http://dsmtuners.com/forums/showthread.php?threadid=65219

it turned out to be the pivot point on the shift fork here on roadrace's web site, all the way at the bottom.
http://www.roadraceengineering.com/clutchandflywheeltech.htm

Check out my post, I had the same problem.

http://dsmtuners.com/forums/showthread.php?threadid=65219

it turned out to be the pivot point on the shift fork here on roadrace's web site, all the way at the bottom.
http://www.roadraceengineering.com/clutchandflywheeltech.htm